Grass Valley Forums Facebook   Twitter   YouTube  

Go Back   Grass Valley Forums > Editors > Editing with EDIUS

Reply
 
Thread Tools Display Modes
Old 01-08-2012, 07:47 PM   #1
col lamb
Guest
 
Posts: n/a
Default Edius 6 fail to load error message

I have been using the full registered version of E6 with no problem until today.

Just fired up the PC and clicked on the E6 start shortcut and got.....................This application may have been installed improperly.

Took out the dongle, re-started PC and inserted dongle, same outcome.

Any ideas
  Reply With Quote
Old 01-08-2012, 08:48 PM   #2
THoff
Senior Member
 
THoff's Avatar
 
Join Date: May 2007
Location: California, USA
Posts: 2,569
Default

First simply try restarting your PC. If that doesn't work, try using System Restore to revert to a state that is known to be good, i.e. if your system worked fine yesterday, go back to the last system restore point before that.

Also run an AV scan, problems with file associations are a common symptom of malware.
THoff is offline   Reply With Quote
Old 01-09-2012, 09:08 AM   #3
col lamb
Guest
 
Posts: n/a
Default

Next, I uninstalled Edius, shut down PC and re-booted.

Installed 6.1, shut down PC and re-booted, Edius 6.1 worked great

Shutdown PC and re-booted Edius 6.1 still OK

Updated to 6.6 and guess what, yes, error message returned

...................This application may have been installed improperly.

Now as I always have a clone copy of my boot disc I inserted that in place of the disc with the faulty Edius installation and all is OK so far.

If Edius stays OK I will just clone the good installation over the bad and problem solved even if the reason for it is not.
  Reply With Quote
Reply
 
Go Back   Grass Valley Forums > Editors > Editing with EDIUS
 

Bookmarks

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Export error message Edius 6.01 MT02MHT Editing with EDIUS 4 01-14-2011 02:55 PM
Edius 4.5 disc too slow error message Stereodesign Editing with EDIUS 72 11-14-2008 03:05 PM
Update Edius 4.51c - Procoder Error Message boyokos Editing with EDIUS 6 09-12-2007 09:51 AM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are Off
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 11:40 PM.


Copyright 2014 Belden Inc. All rights reserved.