Grass Valley Forums Facebook   Twitter   YouTube  

Go Back   Grass Valley Forums > Converters > ADVC

Thread Tools Display Modes
Old 04-03-2008, 01:11 AM   #1
Posts: n/a
Default Final Cut Pro & ADVC300 Set uo


I'm not sure if this is a Canopus issue or an Apple issue, so I'm asking both...

We just installed our new ADVC300. It is connected using firewire to a new iMac 24 which is running Final Cut Studio 2(Final Cut Pro 4.5)

The ADVC300 composite video and analog audio is feeding our TV station analog routing switcher.

The Component out of the ADVC300 is going up to the component input on a monitor in the Final Cut edit suite.

So far, we have not had much luck in seeing either the component or composite output. I'm sure it's a setting in the ADVC300 or in Final Cut Pro. Or both. But so far, I haven't been able to discover the trick. I did install the Mac Software that came with the ADVC300 and when we went into the "View" Menu of Final Cut Pro, when I checked "View all Frames", we did see a still of the last frame of video that was appearing on the edit screen of the Final Cut on component Monitor. But that's as far as I was able to get. Then, when I un-checked View all frames, the (component)monitor went black and when I re-checked View All Frames again, the still frame or no other video was to be seen.

Any Ideas?
  Reply With Quote
Go Back   Grass Valley Forums > Converters > ADVC


Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
ADVC300 - No full connection with Premiere Pro CS3 chimimic ADVC 17 04-18-2018 02:58 PM
I'm new to video editing and need advice on which system to go with and why. keyzone72 Editing with EDIUS 10 05-23-2009 03:51 AM
Supported HD formats from Final Cut Pro in latest Procoder version Kelvomatic ProCoder 12 04-29-2009 12:10 AM
TwinPact 100 with Final Cut Pro traveler7 ADVC 2 06-03-2008 07:51 PM
cant get advc300 to work - mac - final cut russelljeanes ADVC 1 09-24-2007 07:34 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are Off
[IMG] code is On
HTML code is Off

Forum Jump

All times are GMT +1. The time now is 11:56 AM.

Copyright 2014 Belden Inc. All rights reserved.