Grass Valley Forums Facebook   Twitter   YouTube  

Go Back   Grass Valley Forums > Editors > Editing with EDIUS

Reply
 
Thread Tools Display Modes
Old 07-11-2018, 12:36 AM   #11
createmedia
Senior Member
 
createmedia's Avatar
 
Join Date: May 2007
Location: Four Marks, Alton, UK
Posts: 1,185
Default

Updated MB Bios. Fixed issue with NBFX with GPU acceleration freezing on render.

However the PCC GPU acceleration is just not working in Edius WG8 or 9 at UHD 50p, although the GTX1080TI is recognised in settings, the clips play better with PCC applied with the GPU acceleration turned off!!

Yes it pushes the GPU core up to 26% but it is hindering rather than helping playback.

The reason there was the difference between 8 and 9 was the GPU PCC acceleration was off in 8 and on in 9.

Ok so is there an Nvidia control panel setting that would sort this out?

Another couple of things noted are:

1. EWG9 Render a Sony SLOG3 and add to timeline, the render is now reported as BT709 it should maintain SLOG3. Project BT2020/HLG. That doesn't seem right. However the clip hasn't changed from original contrast/brightness so must be wrongly reported.

2. Edius is reporting Sony EI SLOG3 as being SLOG2 in PCC.

Regards

Mike
__________________
Sys4: Z10PE-D16WS MB 2xE5-2696 Xeon 64 active logical cores. EWG9. 64G RAM. Aorus GTX1080Ti. 55" Q7 1500 NIT HDR 4K TV/Storm 3G Elite/Decklink 4K 12G/8CH audio monitoring, Yamaha RXA-870 A/V. Sys1-3 EWG8 + RX-E1+HDBX1000 MIP in HP xw8600 2 x X5492 CPU 8 cores, 8Gig RAM, Quadro FX3800. All sys Fibre to central media pool - 5TB Axus Yotta RAID + QLogic Fibre Switch. Central VCR rack plus YUV & audio to viewing room with Yamaha AX1 7.1 100 watt per channel amp with 1000W sub 63" HD 3D Samsung TV

Last edited by createmedia; 07-11-2018 at 01:08 AM.
createmedia is offline   Reply With Quote
Reply
 
Go Back   Grass Valley Forums > Editors > Editing with EDIUS
 

Bookmarks

Thread Tools
Display Modes

Similar Threads
Thread Thread Starter Forum Replies Last Post
Edius WG9 Deck control createmedia EDIUS: Compatible Hardware and Accessories 16 11-15-2017 02:18 PM
Is it possible to Uninstall Edius WG8 manually myname Editing with EDIUS 1 05-28-2016 12:37 AM
Edius WG8 and missing Robuskey Harro Editing with EDIUS 5 11-01-2015 12:27 AM
Edius WG8 Serial numbers createmedia Editing with EDIUS 4 10-30-2015 12:10 AM
Edius WG8 Isotope filters dano3655 EDIUS: Compatible Third Party Products 9 09-25-2015 06:33 PM

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are Off
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT +1. The time now is 02:03 AM.


Copyright 2014 Belden Inc. All rights reserved.