View Single Post
Old 07-27-2017, 10:45 AM   #1
Steady Hand
Senior Member
 
Join Date: May 2015
Location: Germany
Posts: 148
Default clip processing (trimming)

Mync compared to EDIUS lacks some features like playing with variable speed forward and backwards (at least there are no control buttons for that) and trimming of clips.
I think when previewing your clips one might like to to set In and Out points to the clips (maybe generic clip marks also), so when importing those into EDIUS later, the trim marks would be there already.
So is Mync intended just for viewing and sorting clips, or also for preparing clips for later use in EDIUS?
Steady Hand is offline   Reply With Quote