Adding crossfade to multicam edit?

[warrenp]

Simple question...

What is the procedure to add crossfades between clips after editing with the multicam mode?

For instance, if I have 3 tracks and it cuts between track 1 and 2, I would like to have a crossfade between the two tracks.

Ideally, I could just add crossfades to all of the cuts, but that may not be possible?

Thanks,
Warren

[Rusty]

You can have Edius merge all Multicam tracks into a single (upper) track and add transitions there, but you must allow clips to extend or transitions will not be inserted to the new track.

When I use Multicam I typically stay with all cuts, but when required I like to simply stretch tracks at the appropriate location and use the Fade button on the upper track to create a cross fade.

[kwshaw1]

You can have Edius merge all Multicam tracks into a single (upper) track...

What's the procedure for that?

[Fred Dwyer]

User guide, page 118

[Rusty]

Kevin, you should have seen that one coming!

[tuyle]

==> Mode - Compress to a single track.

[kwshaw1]

==> Mode - Compress to a single track.

Thanks, nice to get a direct answer to a simple question instead of being referred to the manual. But I suppose it couldn't hurt to glance at the manual too...

:-)

[Fred Dwyer]

Kevin:
Fact is the manual is precise and might answer further questions about the multicam mode. I gave you that reference as the most complete answer to your question, not as a put-down. Sorry that you find that offensive.