DV Capture 1.11

[JimG]

I have Edius NX-PCI Express with the NX Bay. When I use DVCapture 1.11, the capture options are
NHX-E2- DV
NHX-E2- S
NHX-E2- Composite

I can capture DV with DVCapture, but I cannot capture S or Composite. If I select S or composite, the capture selection switches to DV.

If I go into Edius 4.54, the capture options are
NHX-E2- DV
NHX-E2- S
NHX-E2- Composite
NHX-E2- Bay S
NHX-E2- Bay Composite

I can capture DV, Bay S, and Bay Composite,
I cannot capture S or Composite (no video seen on the Edius monitor)

How do I add the Bay S and Bay Composite as capture options to DVCapture?

How do I delete S and Composite from the capture options in Edius and DVCapture, since these options are not active?

Thank you for any assistance.

[antonsvideo]

DV capture is only for DV, do you really need this utility?

you can capture from all inputs with Edius capture, including DV, S and composite

in order to capture S or composite from main board inputs, you need to connect a signal to the input of the main board

[JimG]

DV Capture 1.11

Anton,
Thank you for your prompt response. Sometimes I want to use the NHX front bay to capture analog inputs.

I can do this on my DVStorm system which has StormBay with DV, S & Composite inputs.

Why can't I do the same thing with Edius and the NHX-B10 front bay which has DV, S and Composite inputs?

[antonsvideo]

you can capture from the front bay providing the bay is internally connected to the NX board

but you don't use the DVcapture utility to capture S or composite, you use Edius instead

[JimG]

DVCapture 1.11

Anton,
So, Edius front bay capture options are different from DVStorm. This point was my confusion. Thanks for the clarification.