Announcement

Collapse
No announcement yet.

Component Out on Edius NX Express card?

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • tingsern
    replied
    I use "BIG BAD" MONSTER cable for connecting my NX card to my HD broadcast monitor :-).

    Make sure the component cables are shielded for better signal quality.

    Leave a comment:


  • STORMDAVE
    replied
    Monoprice.com for the people in the U.S.

    Grabbed a good quality BNC to RCA (for Bravia input) for cheap.

    As mentioned there's plenty of RCA to BNC adapters out there at your local electronics store (not Best Buy type).

    Leave a comment:


  • shueardm
    replied
    The BNC to RCA adapters are readilly available for a couple of dollars each at most electronic shops, like Radio Shack.


    RE: mariian2teo : umm, you should start a new thread, not ask a totally off topic question during someone elses thread, that's just how it works. Just start a new thread and people will help.

    Leave a comment:


  • SRsupport
    replied
    Eh... Bh has these cables by different brands. if your monitor has bnc you buy bnc to bnc if your monitor has rca you buy bnc to rca. Realy simple

    Leave a comment:


  • luzcanon
    replied
    Ok thanks. I guess I'll just need to get them from B&H. I was at a few stores yesterday and nobody knew what I was talking about asking if there was such a thing as BNC to rca. Simple enough.

    Leave a comment:


  • SRsupport
    replied
    1 There are bnc male to rca female adapters.
    you would then use the rca cables + connector on the nx



    2 Bnc female to rca male.
    You would then use bnc cables and the connectors on your hdtv

    3 bcn to rca cables as in the picture of previous poster (b&H has alot)

    4 you could buy a HD monitor with bnc connectors :)

    Leave a comment:


  • Aristotelis
    replied
    I think that you just need some cables like the one in the picture...
    Attached Files

    Leave a comment:


  • luzcanon
    started a topic Component Out on Edius NX Express card?

    Component Out on Edius NX Express card?

    I can't seem to find an answer to this question but I'm a little confused... I purchased an Edius NX Express recently and had done so after months of researching and trying to settle on the right system for myself. I wanted this version of NX because it had the component output to deliver the HD signal directly from the timeline to an HD television monitor. But from what I see, there is just BNC outputs. I'm confused by this and didn't know BNC cables can support HD. I'm trying to figure out what cables I need if I want to connect the card to a regular HD tv monitor. As far as I know, there is no such adapter to convert BNC to component connectors. I started calling Grass Valley early last week, where I purchased the card through and have left several messages to get a return call back, even stating that I wanted to make an additional purchase, and nobody has returned my call. Any help would be appreciated. I'm very confused.
Working...
X