Announcement

Collapse
No announcement yet.

No Output during Export

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Imagine Video
    replied
    You won't but you will make other mistakes, just as obvious when you find the fault ;-)

    I have done this, and not to long ago! and realised it by re doing from scratch as did you!!

    It must be a workflow thing............

    Leave a comment:


  • DigitalDave
    replied
    I bet I dont make that mistake again!!!!

    However just as an aside what I did notice and suspect it may be an issue is that at the end of Export to Tape, E4.6 Locked up. I tried this again last night just as an experiment and it did the same thing.

    DD

    Leave a comment:


  • GrassValley_KH
    replied
    Er yeah...that would definitely have something to do with it.


    I'll add you to the list of people who want frame rate project switching implemented. :)

    Leave a comment:


  • DigitalDave
    replied
    Gave up Started from scratch and all is well..so much for a 15 minute job!
    ....but then discovered that the original project settings were 50p What a Muppett!!!

    Leave a comment:


  • DigitalDave
    replied
    Originally posted by SRsupport View Post
    David,
    could it be that by mistake you have a hardware preset loaded while you are trying to export via ohci?
    That will leave you in a state of shock. :)
    No this was on the OHCI system so no other Hardware. Overlay cant effect the output can it? Pics from the TL display on the Edius window?

    Leave a comment:


  • SRsupport
    replied
    David,
    could it be that by mistake you have a hardware preset loaded while you are trying to export via ohci?
    That will leave you in a state of shock. :)

    Leave a comment:


  • tingsern
    replied
    I have ... my DVCAM is DSR25 - connected by Firewire to NX Firewire port. Just print to tape ... and it goes. No problems. No experience on using generic OHCI.

    Leave a comment:


  • DigitalDave
    replied
    Originally posted by Rusty View Post
    Easy big fella...

    Check Settings>Hardware Settings>Generic OCHI Settings>(tick) Enable RealTime DV Output
    No that should have been on my list - its not that but I bet it's something as simple as that. Same thing is happening on my other OHCI system.
    I suppose someone out there has output PAL DVCam to tape ??????

    Leave a comment:


  • Rusty
    replied
    Easy big fella...

    Check Settings>Hardware Settings>Generic OCHI Settings>(tick) Enable RealTime DV Output

    Leave a comment:


  • DigitalDave
    started a topic No Output during Export

    No Output during Export

    Simple Cut and shut project in 4.6 OHCI
    Project setting 4x3 50i
    Deck DSR11 set as PAL DVCam and DVin on the front
    Captured 2 sections from 2 tapes so device control worked fine
    Edited the two sections to then be output to a third tape.
    Tab on tape is in rec position
    Marked in and out on TL
    went to export got an error
    Scrubbed TL but saw no output on the E to E of the DSR11 even when in REC
    TL Output shows in Edius window.
    Project settings still PAL 50i
    Tried Reboot shutdown DSR11 there is no video signal coming off the TL

    WTF have I missed ??????

    David
    Last edited by DigitalDave; 03-12-2008, 03:40 PM.
Working...
X