Storm and 4.5+ crash on Start up- Vol 2

[Angelo]

How about disabling OHCI and enabling DVStorm, does it still crash?

...Angelo

[GrassValley_KH]

Hmm, what happens if you disable the audigy instead, and run off the onboard audio?

I did see in the build notes for the latest 4.6 build something about crashes going from the preset screen...it may help folks like yourself in this pickle. *fingers crossed*

There will eventually also be a full installer disc ISO for 4.6 (a little while after release) which you can try - then there's no updates necessary on a fresh XP install...which might also be a possible trigger for mayhem.

[DigitalDave]

Following on from earlier problems, here is a summary.
4.0* works 4.5+ does not crashes at startup screen

Take a new XP install with latest Audigy2 and ATI 9800 Pro drivers. Ghost for testing. No other SW installed
Install vers 4.0 - Storm O/P fine.
Update to 4.54 + but not drivers - crash at startup screen.
Update to 4.54 with drivers - crash at startup screen.
Disable Storm and work via OHCI no problem.

Enable Storm but this time start Edius by double clicking an existing project even a vers3 project - even just a frame of colour bars created in OHCI - this time the Start up screen is by-passed and Storm works fine. Of course if you click "new/project" the crash is induced but restarting Edius from a project folder bypassing the Start-up screen makes it possible to use.
So it IS the Startup screen where the problems occur -with Storm not when Storm is disabled.
I have not actually edited for any length of time to ascertain the overall stability but at least some pin pointing has been achieved.

DD

EDIT
After a few hours of playing I finished up with crash when importing my dummy project and the only way to recover it was to disable Storm but it did work for 180 mins - sigh