Edius was not found

[Harro]

The dongle in in the USB port. All works fine in 4.24, I just get the message when I tried to upgrade to 4.51c. I will wait for 4.52 to be released and try again.

[GrassValley_BH]

Also make sure you have the EDIUS dongle in your USB port.

[Harro]

Thank you Anton for your response. This Forum is indeed a worthy place to obtain very useful information and tips.

[Rusty]

careful!

That sounds like Sooooooon!

Rusty

[pjsssss]

KH said it was due out the first week in Oct.

[Trax]

4.5 is a full installer, no need to use it

4.51c is an update to update an existing version, I recommend you wait for next update (a few days away) because there are some nasty problems in 4.51c

When will 4.52 published?

[antonsvideo]

4.5 is a full installer, no need to use it

4.51c is an update to update an existing version, I recommend you wait for next update (a few days away) because there are some nasty problems in 4.51c

[Harro]

I am hoping that someone may be able to help me with this problem. I downloaded Edius 4.5 and 4.51c some time ago, but since I was half way through a project, did not wish to update. I now want to update, but when I run Setup Manager for Edius I am informed that "Edius was not found. This update will not proceed".

Edius is indeed present and has been since v1.0. I did a clean install of v4.24 when that became available. What do I have to do to update to v4.51c? (Is there a newer version coming soon, maybe that will update properly).

Thanks in anticipation.

Harro.