burned to disc error: failed to encode

[jimstamos]

never had a problem burning a dvd off timeline. now im getting failed to encode halfway through the project. 45 minute clip, even made an hq file and tried doing that?
any ideas?

[Jerry]

Full project settings and clip properties. Also, what were your encoding settings?
Is this in 6.07 or 6.51?

[jimstamos]

ok, im outputting to C temp folder
project settings:1920x1080 29.97upper field , 8bitaudio, 48000, quantization bit rate 24bit

clip settings: canopus hq file

encoding settings: burning off timeline.where are these encoding setting?
i get through 56% of the process then the error comes up

[jimstamos]

under windows folder in c drive is a temp folder. do i delete those?

[jimstamos]

ok, jerry on that same timeline, just burned a shorter clip and it was fine... this is ridiculous.what about the temp folder on c drive in the windows folder, do i delete those period?regualrly?thankx

[Jerry]

If you move the temp folder to another drive, any other drive than the C drive, does it burn?

[antonsvideo]

never use the Temp folder, browse for a dedicated folder in detailed settings on another drive, not the C drive

what are your video and audio bitrate settings in the Movie Tab?

what is your EDIUS version?

[jimstamos]

version 6.07

[antonsvideo]

what audio type did you choose in the disk burner? from memory, EDIUS 6.07 had a problem with wave audio in disk burner

so use bitrate 7700max for video and 256 ac3 dolby digital for audio

make sure project setting is 2 channel 4800

in disk burner enable detailed settings and set work folder to another location other than C

daily empty the temp folder in C/Users/Username/Appdata/Local/ (I have a desktop shortcut to that folder)

use good quality disks, use DVD-R JVC (formerly Yaiyo Yuden) or Verbatim 6x Blu-ray