Same old driver problem again HX-E2!!!!

[tdtinker]

Nothing new has been added to this system, but this morning it has decided not to recognize the the NX card. I have uninstalled and reinstall the device 3time but all I get is "windows encountered a problem installing the driver."
Any suggestions????
tdtinker

[tdtinker]

Anyone????

[antonsvideo]

uninstall the hardware drivers

reboot and confirm in device manager that there is an unknown device, if not, see if you can uninstall it from device manager and reboot

http://www.videoproductions.com.au/edius6/device-manager-uninstall.png

empty temp folder

install EDIUS hardware drivers

[Rusty]

What was the minimum version for NX, 6.03?
Just installed 6.00 to 6.05 NX on a new system, no problems!

[tdtinker]

What was the minimum version for NX, 6.03?
Just installed 6.00 to 6.05 NX on a new system, no problems!

I had no problem until two days ago. Nothing has been added to the system. It just decided to stop seeing the card. After deleting and restarting the system 3 times today it finally as seen the card. Strange?
TDTinker

[antonsvideo]

I had no problem until two days ago. Nothing has been added to the system. It just decided to stop seeing the card. After deleting and restarting the system 3 times today it finally as seen the card. Strange?
TDTinker

I am beginning to suspect a bad mobo

[GrassValley_BH]

Anton's probably right. Either a BIOS incompatibility issue, a physical installation issue (not seated right), or a motherboard component going/gone bad.

[Sausage]

I had something similar with my NX card. Took it out and reseated it - all ok.

Peter