EDIUS 6 - Error in preset settings

[zvit]

If I had know it was a legacy issue and searched "legacy", I would have found it. But I searched other capture issues and didn't find it here. Strange, because then I saw it was discussed here a lot.

[antonsvideo]

the Legacy driver issue is discussed here every day, I am surprised you have not noticed it

[zvit]

I resolved the capture problem. Even though it still gives me a warning that the preset has problems (like a mentioned in the original post), at least I can capture. I found the solution on a another forum and I will just copy the thread:

Hi, I had the same problem. I then updated my IEEE OHCI device driver to the legacy version, instead of the installed Texas Instruments version. Choose manual and "let me pick", then you will probably see 3 different drivers. Choose the legacy version. (1394 OHCI Compliant Host Controller (Legacy))

After that I could capture.

This solved it for me too.

[GrassValley_SL]

Ok I will send this to the engineers so they can have a look at it.
When I get an answer I will post it here .

[zvit]

Same problem.

[GrassValley_SL]

Can you try it with output set to not select.

[zvit]

Here it is.

[zvit]

In Edius 6, I can control the camera (play, stop etc...) but I just see a gray window (no picture) and of course it won't capture.

Like I said, I have tried all presets but I will zip the one that SHOULD work.

[GrassValley_SL]

Can you export your device preset zip it and attach it so we can have a look at it?

[zvit]

Panasonic AG-DVC200

In Edius 5, it captured fine.

[GrassValley_SL]

WHat is the device ?

[zvit]

Yes, I have tried that already.

[shueardm]

Have seen this myself. Just delete it and start a new?

[zvit]

I'm trying to set up a capture device in system settings. No matter what setting I choose, default or not, I get a warning after saying "There is an error in the preset settings". (Believe me, I tried every setting) Any ideas?